How to replace the original shock absorber of MN MODEL MN333(S) with a metal shock absorber?
Oct 21, 2025
by mnrccars
Replacing the shock absorber of MN333(S) with a metal one:
This metal shock absorber is slightly longer than the original one. First, remove the original shock absorber by taking out the two screws (one at the top and one at the bottom). Then, remove the ball joint—this ball joint is no longer needed. Next, remove the small ball joint from the top of the original shock absorber; this small ball joint needs to be installed on the tie rod with the larger end facing inward.
>>>Click here to buy: MN Model MN333(S) RC Car Parts Universal V3 Multifunctional Shock Absorber Pliers & Ball Joint Pliers AM-190031
For installing the metal shock absorber: the original screw for the bottom position is not long enough, so replace it with a 2mm diameter and 20mm length screw. Pass the screw through the shock absorber and then through the tie rod, align it with the screw hole on the axle, and tighten the screw. Then tighten the top screw of the shock absorber—this screw can use the original one, no need for replacement.
The metal shock absorber replacement is now complete; just install the tire. The installation method for all four shock absorbers is the same. Let's review the front shock absorber installation again: the operating space at the front is smaller than that at the rear, making installation a bit inconvenient, but the method is identical.